Supa L16 - Bypass Zone

Bypass Zone
LCD Keypad display
1) Press [ # ] + [ 6 ]
(If Quick Bypass is enabled)
Or
Press [ User Code ] + [ 6 ] + [Partition Select ]
☼ The Line light will blink to indicate Bypass mode.
2) Press [ Zone Number ]
☼ The respective zone light will turn on to indicate the zone is bypassed.
☼ The respective zone light will turn off to indicate the zone is un-bypassed.
3) Press [  ] to exit Bypass mode
☼ The Line light will turn off to indicate exit from Bypass mode.
♪ 3 beeps to indicate exit from Bypass mode.
Information
● Bypass is performed to eliminate burglary zones that are not ready or faulty from activating
burglary alarm. Protection to a bypassed zone is temporarily switched off until the next system
arming.
● To un-bypass previously bypassed zones, simply Disarm the system to cancel bypass state of all
zones or enter bypass mode and press the corresponding bypassed zone number to toggle its
bypass state to un-bypass state. After un-bypassing a zone, the bypass indication will be removed
from that particular zone.
● No bypass or un-bypass of zones is allowed during system Arm.
L8_UM1016-v1.0
6
Bypass PtSelect?
P1[] P2[] P3[] P4[]
Bypass Z01-08/Z09-16
– – – – – – – – – – – – – –
www.ealarm.com.my