Supa L16 - Programming User Codes; Deleting User Codes

Programming User Codes
1) Press [ Master Code ] + [ 7 ]
☼ The Line light blinks to indicate Programming mode.
2) Enter 4-digit address location [ ] [ ] [ ] [ ]
☼ The existing code will be displayed by the keypad
4-Digit Address Location User Type Level
0401 Master User / User-1 Priority
0403 User-3 Priority
0404 User-4 Priority
0405 User-5 Priority
0406 User-6 Non priority
0407 User-7 Non priority
0408 User-8 Non priority
0409 User-9 Non priority
0410 User-10
Non priority
0411 User-11
Non priority
0412 User-12
Non priority
0413 User-13
Non priority
0414 User-14
Non priority
0415 User-15
Non priority
0416 User-16
Non priority
0417 User-17
Non priority
0418 User-18
Non priority
0419 User-19
Non priority
0420 User-20
Non priority
3) Enter a new 4-digit User code [ ] [ ] [ ] [ ]
♪ 3 beeps to indicate a new 4-digit code is entered.
☼ You may continue to enter a new address location to program another User code.
4) Press [  ] to exit Programming mode
☼ The Line light will turn off to indicate exit from Programming mode
Deleting User Codes
1) Press [ Master Code ] + [ 7 ]
☼ The Line light blinks to indicate Programming mode.
2) Enter 4-digit address location [ ] [ ] [ ] [ ]
3) Press [ # ]
♪ 3 beeps to indicate code is deleted.
4) Press [  ] to exit Programming mode
☼ The Line light will turn off to indicate exit from Programming mode
Information
● User-2 is designated as Installer code. You are not allowed to program or change Installer code.
● All zone lights off to represent digit ‘0’ on keypad.
L8_UM1016-v1.0
12
www.ealarm.com.my