Restricting Installer Code
1) Press [ Master Code ] + [ 7 ]
☼ The Line light blinks to indicate Programming mode.
2) Enter 4-digit address location [ 0 ] [ 8 ] [ 1 ] [ 7 ]
☼ The existing value will be displayed by the keypad lights
3) Enter a 3-digit value [ 0 ] [ 1 ] [ 3 ]
♪ 3 beeps to indicate a 3-digit Installer restrict value is entered.
4) Press [ ] to exit Programming mode
☼ The Line light will turn off to indicate exit from Programming mode
Information
● To re-enable Installer code use, enter value ‘014’.
● This is a safety measure whereby no other codes are allowed to program your system other than
the users of this security alarm system.
L8_UM1016-v1.0
To Next Page
Loading...