Call-Out Beeping Tone Menu
1) User pick up call
♪♪♪♪ High and low tones to indicate Emergency / power not present
♪ Number of beeps indicate corresponding triggered zone
2) Press [ ] to enter Main menu
3) Enter [ User Code ]
♪♪♪♪ Ascending tone to indicate user entered main menu.
♪♪♪♪♪♪ High middle tone to indicate multi partition code entered. User need to select partition.
♪~♪ Illegal code entry. Retries until 8 times.
4) Press any of the below keys to perform desired function.
Key Menu Function
Tone Indication
1 Away Arm Arm system in Away mode 2 beeps
2 Home Arm Arm system in Home mode 2 beeps
3 Disarm/Off Disarm system and cancel alarm 1 beep
# System status Announce system status
2 beeps indicate Arm.
1 beep indicates Disarm.
4 Bypass
Bypass zone. Enter the zone number
you wish to bypass or un-bypass. Press
[ ] to exit this mode.
2 beeps indicate bypass zone.
1 beep indicates un-bypass zone.
Ascending tones indicates return to
Main menu.
6 Panic Switch On Siren and Strobe light only
High and Low beeps indicate Panic.
Ascending tones indicates return to
Main menu.
7
Check
Emergency
Announce emergency status type
1 beeps for Fire
2 beeps for Panic
3 beeps for Medical
4 beeps for AC fail
5 beeps for Battery low
Hang up End Call-out function and hang up Long beep
Information
● Call-Out function refers to Personal reporting format as part of the features available in your alarm
security system. Please check with your installer if this feature is enabled.
● If User picks up a call and enters Main menu, the system will not call the next in line telephone
number. The system will only call the next number when user immediately ends the call after
listening to system Arm/Disarm status or alarm event in beeping tones.
● If the call to the first programmed telephone number has not been picked up, the system will
cancel the call and dial the next telephone number in line.
● The system will not perform Call-out function once the maximum number of group dial attempts
programmed in the system is reached and no User/receiving party have picked up the calls.
● If the system does not receive any command key entry in the Main menu for periods longer than
10 seconds, it will hang up immediately.
● You may only bypass zones if your system is in Disarm state.
L8_UM1016-v1.0
19
To Next Page
Loading...