Superchips TrailDash - Alert Notification System; Main Screen Alert Method; Alerts Screen Display Method

22
The TrailDash is equipped with an
alert system that noties the user
when vehicle parameters are out-
side a user-dened value. There are
a few ways the alerts are indicated
and accessed:
MAIN SCREEN METHOD
If one of your gauges on the main
screen contains the alert param-
eters, 2 things will occur:
1. The alert notication will sound
only if it is turned on. (Sound will
turn o after a few seconds depend-
ing on the sound duration you have
set)
2. The gauge back-light will ash.
(Will continue ashing as long as
the parameter is outside the user-
dened value)
NOTE: The alert sound and ashing
will discontinue once parameter is
no longer out of the user-dened
value.
ALERTS SCREEN METHOD
This Alerts screen will show all pa-
rameters for which an alert has been
set. If an alert value is outside the
user-dened setting, it will ash red.
The Alerts screen will stay in view for
a minimum of three seconds, until
no alert condition exists, or until the
screen/menu button is touched, at
which point it will return to the main
gauge screen.
NOTE: This menu only appears
when there is an alert active. It
shows the current, active alerts and
their current values.
If you have exited the Alerts screen,
you can return to the screen by en-
tering the “Main Menu” and select-
ing the “Show Alerts” option.
NOTE: For more information on
how to setup the Alerts, Refer to
the: “ALERT OPTIONS” section of
this manual.
SHOW ALERTS