6-5
Chapter 6: Advanced Chassis Setup and Maintenance
Installing 3.5" Fixed Hard Drives
One or two 3.5" hard drives may be installed. Refer to Figures 6-4 and Figure 6-6.
Installing 3.5" Hard Drives
The 3.5" hard drive screws directly into the chassis.
1. Power down the system as described in Section 6-2 and remove the cover.
2. Place the hard drives into the chassis, as illustrated in gure 6-4 and 6-6.
• Orient a single drive with the cable connections facing the rear of the chassis.
• Orient two drives with the cable connections facing the left of the chassis.
3. Secure the hard drives to the chassis oor by inserting the screws up through
the underside of the chassis.
4. Connect the hard drive wiring.
5. Reinstall the chassis cover and power cord and then power up the server.
To Next Page
Loading...
