101
SuperServer 1019C-HTN2 User's Manual
Appendix A
BIOS Error Codes
A.1 BIOS Error POST (Beep) Codes
During the POST (Power-On Self-Test) routines, which are performed each time the system
is powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the boot-up
process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot-up procedure. If
a fatal error occurs, you should consult with your system manufacturer for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The table
below lists some common errors and their corresponding beep codes encountered by users.
BIOS Error Beep (POST) Codes
Beep Code Error Message Description
1 beep Refresh Circuits have been reset (Ready to power up)
5 short, 1 long Memory error No memory detected in system
5 beeps No con-in or con-out devices
Con-in includes USB or PS/2 keyboard, PCI or
serial console redirection, and IPMI KVM or SOL
Con-out includes the video controller, PCI or serial
console redirection, and IPMI SOL
1 or more beeps Refresh 1 beep for each USB device detected
IPMI Error Codes
Beep Code Error Message Description
1 long continuous System OH System overheat condition
To Next Page
Loading...
