SuperServer 1019C-HTN2 User's Manual
20
Chapter 3
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
numbers given.
system. Please follow the procedures given in each section.
3.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut-down, disconnect the AC power cord from the
power strip or outlet.
3. Disconnect the power cord from the power supply module.
3.2 Accessing the System
The SC510FT-203B features a removable top cover, which allows easy access to the inside
of the chassis.
Removing the Top Cover
1. Begin by removing power from the system as described in Section 3.1.
2.
each side of the chassis and one screw on the back.
3. Lift the cover upward to remove it from the chassis. See Figure 3-1.
Warning: Except for short periods of time, do not operate the server without the cover in place.
To Next Page
Loading...
Need help?
General
