SuperServer 1019C-HTN2 User's Manual
48
4. During Windows Setup, continue to the dialog where you select the drives on which to
install Windows. If the disk you want to use is not listed, click on “Load driver” link at the
bottom left corner.
Figure 5-2. Load Driver Link
• For RAID, choose the SATA/sSATA RAID driver indicated then choose the storage drive
on which you want to install it.
• For non-RAID, choose the SATA/sSATA AHCI driver indicated then choose the storage
drive on which you want to install it.
5.
6. After the Windows OS installation has completed, the system will automatically reboot
multiple times.
To Next Page
Loading...
Need help?
General
