SuperServer E403-9P-FN2T User's Manual
86
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization Support. The options are
Disabled and Enabled.
MMIO High Base
Use this feature to select the base memory size according to memory-address mapping for
the IO hub. The options are 56 T, 40 T, 24 T, 16 T, 4 T, 2 T, and 1 T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for
the IO hub. The options are 1 GB, 4 GB, 16 GB, 64 GB. 256 GB, and 1024 GB.
Maximum Read Request
Use this feature to select the Maximum Read Request size of the PCI-Express device, or
select Auto to allow the System BIOS to determine the value. The options are Auto, 128
Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
MMCFG Base
Use this feature to select the low base address for PCIE adapters to increase base memory.
The options are 1G, 1.5G, 1.75G, 2G, 2.25G. and 3G.
NVMe Firmware Source
pre-installed on the drive and may resolve errata or enable innovative functions for the drive.
options are Vendor Dened Firmware and AMI Native Support.
VGA Priority
Use this feature to select VGA priority when multiple VGA devices are detected. Select On-
graphics card. The options are Onboard
M.2 PCI-E 3.0 x4 OPROM
The options are Disabled, Legacy, and EFI.
Onboard SAS Option ROM
Select Enabled to enable SAS Option ROM support to boot the computer using a SAS device
Legacy, and EFI.
Bus Master Enable
This feature enables a device connected to the bus to intiate Direct Memory Access (DMA)
transactions. When DIsabled is selected, the PCI Bus Driver disables Bus Master Attribute
for Pre-Boot DMA Protection. When Enabled is selected, the PCI Bus Driver enables BUs
To Next Page
Loading...
