Supermicro SuperServer SYS-221BT-DNTR - Quick Reference Table

18
Chapter 1: Introduction
Quick Reference Table
Jumper Description Jumper Setting (Bold: Default)
JBT1 CMOS Clear Open (Normal)
JPME1 ME Recovery Pins 1/2: Normal, Pins 2/3: ME Recovery
JPME2 ME (Manufacture Mode) Select Pins 1/2: ME Mode
LED Description Status
LE1 CPLD Heartbeat LED On: Complex Programmable Logical Device (CPLD) Normal (Active)
LE6 Power Status LED
Green: Power On
Amber: Standby Power
Red: Power Failure
UID_LED1/
LEDBMC
Rear Unit Identier (UID)
LED/BMC Heartbeat LED
Solid Blue (working as a UID LED): Unit Identied
Blinking Green (working as a BMC LED): BMC Normal (Active)
Solid Green: During BMC Reset or during a Cold Reboot
Connector Description
Battery (BT1) Onboard battery
BMC_LAN (IPMI_LAN1) Dedicated BMC LAN port on the I/O backplane
COM1 (JCOM1) Serial/COM port header
JAIOM
Supermicro Advanced input/output Module (AIOM) PCIe 5.0 x16 slot supported
by CPU1
JNCSI1
NC-SI (Network Controller Sideband Interface) connector (See Note 1 on the
next page.)
JTPM1 Trusted Platform Module/Port 80 connector
JPWR1~JPWR4 6-pin power connectors (1~4)
NS1 P1 NS1 PCIe 5.0 x8 connector supported by CPU1
NS2 P2 NS2 PCIe 5.0 x8 connector supported by CPU2
NS3 P2 NS3 PCIe 5.0 x8 connector supported by CPU2
Slot1 P1 Slot1 PCIe 5.0 x16 supported by CPU1
Slot2 + Slot2A P2 Slot2/Slot2A PCIe 5.0 x16 to support riser card(s)
SXB1 P2 SXB1 PCIe 5.0 x16 supported by CPU2
SXB3 P1 SXB3 PCIe 5.0 x8 supported by CPU1
SXB4 P1 SXB4 PCIe 5.0 x8 supported by CPU1
SXB5 (NVMe M.2)
P1 SXB5 PCIe 5.0 x8 for two NVMe M.2 devices in the M-Key 2280 or 22110
format (depending on the type of riser card used) supported by CPU1 (See Note
2 on the next page.)
SATA 0~7 (SATA1)
SATA connector with support of eight Intel® PCH SATA 3.0 connections (RAID 0,
RAID 1, RAID 5, and RAID 10 supported)
SATA 8~11 (SATA2) SATA connector with four SATA connections (SATA 8~11)
UID Button (JUIDB1) Unit Identier/BMC Reset switch/button on the rear I/O panel
USB0/1 (3.0) (JUSB1) USB 3.0 connector on the rear I/O panel for two USB parts (Port0/Port1)
VGA (JVGA1) Rear VGA connector
VROC RAID Key (JRK1) Intel VROC key header for NVMe RAID support (See Note 3 on the next page.)