Supermicro SuperServer SYS-221BT-DNTR - Accessing the System; Removing a Computing Node Drawer

28
Chapter 3: Maintenance and Component Installation
Removing a Node
1. Use the operating system to power down the node.
2. Remove any cables attached to the outside of the node.
3. Press the lock tab towards the center of the chassis.
4. Press the release latch downwards and use the handle to pull the node from the
chassis.
Node Handle
3.2 Accessing the System
Removing a Computing Node Drawer
Lock Tab
Release
Latch
Figure 3-1. Removing a Node Tray