Supermicro SuperServer SYS-221BT-DNTR - Removing the Processor Carrier Assembly from the PHM

41
Chapter 3: Maintenance and Component Installation
Removing the Processor Carrier Assembly from the PHM
To remove the processor carrier assembly from the PHM, please follow the steps below:
1. Detach the four plastic clips (marked a, b, c, d) on the processor carrier assembly from
the four corners of the heatsink (marked A, B, C, D) as shown in the drawings below.
2. When all plastic clips are detached from the heatsink, remove the processor carrier
assembly from the heatsink.
Pin 1
a
c
b
d
A
C
D
B
Pin 1
a
c
b
d
A
C
D
B
SP XCC HBM
Pin 1
a
c
b
d
A
C
D
B
SP MCC
2U Heatsink (View of Component Side and Heatsink Bottom Side)
SP XCC
HBM
SP MCC
2U Heatsink (View of Component Side and Heatsink Bottom Side)