53
Chapter 3: Maintenance and Component Installation
Figure 3-6. Removing a Dummy Drive from the Drive Carrier
Installing a Drive
1. Install a new drive into the carrier with the printed circuit board side facing down so that
the mounting holes in the drive align with those in the carrier.
2. Secure the hard drive into the carrier with the screws.
Figure 3-7. Installing the Hard Drive
3. Insert the drive and carrier into its bay vertically, keeping the carrier oriented so that
the release button is on the bottom. When the carrier reaches the rear of the bay, the
release handle starts to retract.
4. Push the upper part of the drive carrier handle until it clicks into the locked position.
To Next Page
Loading...
