63
Chapter 3: Maintenance and Component Installation
3. If the riser card (p/n RSC-P2R-88G5) is not installed, attach the riser card to the riser
card bracket.
4. Insert one or two expansion cards into the riser slot to create an assembly.
Figure 3-17. Installing the Expansion Card
Riser Card
Riser Card
Bracket
PCI Slot
Expansion Cards
5. Align the assembly with SLOT1 on the motherboard and the PCI slot shield at the
chassis rear.
6. Insert the assembly into the motherboard and install a screw to hold the expansion card
to the chassis.
7. Connect cables. See Section 3.12 Figure 3-22.
8. Reinstall the expansion card screw, reinsert the node into the chassis and power up the
system.
To Next Page
Loading...
