Supero C7H61 User Manual

Chapter 4: AMI BIOS
4-13
IDE Mode
The following items are displayed when IDE Mode is selected:
Serial-ATA Controller 0~1
This feature is used to activate/deactivate the SATA controller, and sets the
compatibility mode. The options are Disabled, Enhanced and Compatible.
The default of Serial-ATA Controller 1 is Enhanced.
SATA Port0~Port3
This item displays the information detected on the installed SATA drives
on the particular SATA port.

PCIe/PCI/PnP Conguration
This feature allows the user to set the PCI/PnP congurations for the following items:
PCI ROM Priority
When there are multiple Option ROMs (Legacy and EFI compatible), this feature
species what Option ROM to launch. The options are Legacy ROM and EFI
Compatible ROM.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus. Select
64 to set the PCI latency to 64 PCI bus clock cycles. The options are 32 PCI Bus
Clocks, 64 PCI Bus Clocks, 96 PCI Bus Clocks, 128 PCI Bus Clocks, 160 PCI
Bus Clocks, 192 PCI Bus Clocks, 224 PCI Bus Clocks and 248 PCI Bus Clocks.
Active State Power Management
Select Enabled to enable Active-State Power Management for signal transactions
between L0 and L1 Links on the PCI Express Bus in order to maximize power-
saving and transaction speeds. The options are Disabled, Auto, and Force L0.
PCIe Max Read Request Size
This item manually sets the maximum read request size of the PCI Express device
or allows the system BIOS to choose the value (Auto). The options are Auto, 128
Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes and 4096 Bytes.
PCI Slot 1, 2, 3, 4, 5 Option ROM
Use this feature to enable or disable PCI slot Option ROMs. The options are Dis-
abled and Enabled.
Serial Port Number
This feature allows the user decide which serial port to be used for Console Redirection. The options are COM 1, COM 2 and COM 3.
Note: Serial Over LAN (SOL) is enabled on COM 3 on the X9SCM/X9SCM-F.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection. The options are 115200 8, n 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1;
and 9600 8, n, 1.
Flow Control
This feature allows the user to set the ow control for Console Redirection. The options are None, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test (POST). Select Always to keep Console Redirection active all the time after POST.
(Note: This setting may not be supported by some operating systems.) Select Boot Loader to keep Console Redirection active during POST and Boot
Loader. The options are Disabled, Boot Loader, and Always.
Terminal Type
This feature allows the user to select the target terminal type for Console Redirection. The options are ANSI, VT100, and VT-UTF8.
VT-UTF8 Combo Key Support
A terminal keyboard denition that provides a way to send commands from a remote console. Available options are Enabled and Disabled.
Sredir Memory Display Delay
This feature denes the length of time in seconds to display memory information. The options are No Delay, Delay 1 Sec, Delay 2 Sec, and Delay 4 Sec.

Supero C7H61 Specifications

General

Brand	Supero
Model	C7H61
Category	Motherboard
Language	English