Chapter 7: BIOS
7-17
ASPM Support
This feature allows the user to set the Active State Power Management (ASPM)
level for a PCI-E device. Select Force L0 to force all PCI-E links to operate at L0
state. Select Auto to allow the system BIOS to automatically set the ASPM level for
the system. Select Disabled to disable ASPM support. The options are Disabled,
Auto, and Force L0s.
Onboard LAN Option ROM Select
This feature selects whether to load the iSCSI or PXE onboard LAN option ROM.
The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM. This
is to boot the computer using a network device. The default setting for LAN1 Option
ROM is Enabled. the default setting for LAN2 Option ROM is Disabled.
VGA Priority
Use this feature to specify which graphics controller to be used as the primary boot
device. The options are Onboard and Offboard (VGA).
Network Stack
Select Enabled to enabel PXE (Preboot Execution Environment) or UEFI (Unifi ed
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
Super IO Confi guration (WPCM450)
Super IO Chip
Displays the Super IO chip type.
Serial Port 0 Confi guration/Serial Port 1 Confi guration
The submenus allow the user to confi gure the following settings for Serial Port
0 or Serial Port 1:
Serial Port
Select Enabled to enable a serial port specifi ed by the user. The options are
Enabled and Disabled.
To Next Page
Loading...
General