EasyManuals Logo

Supero SUPERSERVER 7047R-TRF User Manual

Supero SUPERSERVER 7047R-TRF
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
A-1
Appendix A: BIOS POST Error Codes
Appendix A
BIOS POST Error Codes
During the POST (Power-On Self-Test) routines, which are performed each time
the system is powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the
boot-up process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot-up
procedure. If a fatal error occurs, you should consult with your system manufacturer
for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The
numbers on the fatal error list (on the following page) correspond to the number
of beeps for the corresponding error. All errors listed, with the exception of Beep
Code 8, are fatal errors.
A-1 AMIBIOS Error Beep Codes
Beep Code Error Message Description
1 beep Refresh Circuits have been reset (Ready to power up)
5 short beeps and 1
long beep
Memory error No memory detected in the system
5 long and 2 short
beeps
Display memory
read/write error
Video adapter missing or with faulty memory
1 Continuous beep System OH System Overheat

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Supero SUPERSERVER 7047R-TRF and is the answer not in the manual?

Supero SUPERSERVER 7047R-TRF Specifications

General IconGeneral
BrandSupero
ModelSUPERSERVER 7047R-TRF
CategoryServer
LanguageEnglish