Chapter 2: Installation
2-5
Mounting Holes
Motherboard
Screw#1
Screw#2
Heatsink Bracket
Installing a Passive CPU Heatsink
Do not apply any thermal grease to the heatsink or the CPU die -- the re-1.
quired amount has already been applied.
Place the heatsink on top of the CPU so that the four mounting holes are 2.
aligned with those on the Motherboard's and the Heatsink Bracket under-
neath.
Screw in two diagonal screws (i.e., the #1 and the #2 screws) until just snug 3.
(-do not over-tighten the screws to avoid possible damage to the CPU.)
Finish the installation by fully tightening all four screws.4.
Recommended Supermicro
heatsink:
SNK-P0046P heatsink with BKT-
0028L bottom bracket
To Next Page
Loading...
Need help?
General
