3-2
X9SCM/X9SCM-F/X9SCL/X9SCL-F User's Manual
No Video
If the power is on, but you have no video--in this case, you will need to re-1.
move all the add-on cards and cables rst.
Use the speaker to determine if any beep codes exist. (Refer to Appendix A 2.
for details on beep codes.)
Remove all memory modules and turn on the system. (If the alarm is on, 3.
check the specs of memory modules, reset the memory or try a different one.)
Memory Errors
Make sure that the DIMM modules are properly installed and fully seated in 1.
the slots.
You should be using unbuffered ECC DDR3 (1.5V) 1333/1066 MHz memory 2.
(recommended by the manufacturer). Also, it is recommended that you
use the memory modules of the same type and speed for all DIMMs in the
system. Do not use memory modules of different sizes, different speeds and
different types on the same motherboard.
Check for bad DIMM modules or slots by swapping modules between slots to 3.
see if you can locate the faulty ones.
Check the switch of 115V/230V power supply.4.
LosingtheSystem’sSetupConguration
Please be sure to use a high quality power supply. A poor quality power sup-1.
ply may cause the system to lose CMOS setup information. Refer to Section
1-5 for details on recommended power supplies.
The battery on your motherboard may be old. Check to verify that it still sup-2.
plies ~3VDC. If it does not, replace it with a new one.
If the above steps do not x the Setup Conguration problem, contact your 3.
vendor for repairs.
To Next Page
Loading...
Need help?
General
