21
i
EN
11.
Feed in the belt.
7. Flush mounting
Belt path when ush-mounted.
This sectional diagram shows the belt
path within the belt winder.
NOTE
If the fastening hook is not accessible,
plug the mains adapter into the mains
socket and drive the hook into the
right position with the control buttons.
Subsequently pull the mains adapter
out of the socket again.
12.
Pull the belt over the fastening
hook.
Belt end
Belt inlet
Fastening
hooks
Belt
End of belt
Draw-in the belt into the belt winder
from the top.
Continue to feed the belt into the de-
vice as shown in the bottom sectional
diagram and subsequently slide the
belt over the fastening hook from
below.
To Next Page
Loading...