EasyManuals Logo

Suzhou Monarch Control Technology MCTC-GCB-A User Manual

Default Icon
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
Function parameter description NICE3000 User Manual
150
Brake output pre-run output
For special asynchronous master machine use, special treatment for time sequence; invalid for
sync machine.
Independent running: Its not in parallel (group control), and it gets into the independent
running condition through the independent running switch in the car cage. At the moment, the
lift doesnt respond to the hall call and the door operation is the same with th
at in motorman
condition, which means theres no automatic door closing and it opens the door automatically
if it fails to complete closing the door. If its in the parallel (group control) state, the system will
get off the parallel (group control) in self-motion.
Maintenance automatic close door: When the machine room is in the maintenance operation,
if the car cages door isnt closed, it will c
ause the lifts door lock block and the lift
cant travel. If choose this function, press UP and DOWN button, the lift will close the door
automatically when its in maintenance. Theres no close door signal outputting if you dont
press UP and DOWN button.
Car call miss delete: If you are ready to delete the registered car call command, press the call
button twice continuously (interval time aroun
d 0.5s), the system will cancel this call. However,
if the car call has been locked by the lift, you cant delete this call command.
Hall call miss delete: If you are ready to delete the registered hall call command, press the call
button twice continuously (interval time around 0.5s), the system will cancel this call.
Emergency auto-running car: While it uses permanent-magnet synchronous motor, the
lift can
fulll auto-running car through the enclosed star contactor when theres power failure and
it opens the door when it slides to the leveling position. This function enables the economical
emergency rescue realize.
Emergency auto-rescue overtime protection: If the car cage is in balance load or the rescue
driving powers capacity is not adequate, it will cause long emergency rescue time and
even
dangers occur. This function enables to stop rescuing when auto-running car rescue time is
over 100s, and rescue driving time is over 50s.
Door lock jump-out test: If door lock jump-out is found after door open limit, the system alarms
E53 when the lift is running in normal condition.
Door opening limit keep open: If choose this function, the lift keep outputting open door signal
when theres
door opening limit.
No output door closing signal when running: If choose this function, the lift doesnt output
close door signal when it is running.
Door close maintenance detects door close limit: If choose this function, the system can judge
the door close limit signal in the door close maintenance function. If not, the system can only
judge the door close limit situation through door lock signa
l.
Contactor conglutination recover automatically: Detect the brake, and traveling contactors
feedback contacts, alarm E36, E37 if the contacts are deviant, and it cant recover
automatically. If the two errors occur, this function enables to recover automatically no more
than three times as long as these errors disappear.
Force reducer switch conglutination inspection: This function enables to mon
itor the force

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzhou Monarch Control Technology MCTC-GCB-A and is the answer not in the manual?

Suzhou Monarch Control Technology MCTC-GCB-A Specifications

General IconGeneral
BrandSuzhou Monarch Control Technology
ModelMCTC-GCB-A
CategoryController
LanguageEnglish

Related product manuals