Suzuki drz 400E Service Manual

2-12 PERIODIC MAINTENANCE
Replace the oil filter cap and tighten the nut securely.
Add new engine oil and check the oil level as described in the
engine oil replacement procedure.
Engine oil capacity
Oil change: 1.7 L (1.8 US qt, 1.5 Imp qt)
Oil and filter change: 1.8 L (1.9 US qt, 1.6 Imp qt)
Engine overhaul: 1.9 L (2.0 US qt, 1.7 Imp qt)
When reassembling the oil filter, make sure that the oil
filter is installed as shown above. If the filter is installed
improperly, serious engine damage may result.
ENGINE OIL HOSES
Inspect initially at five hours of operation and every
30 hours thereafter.
Inspect the engine oil hoses for damage and oil leakage. If any
damages are found, replace the engine oil hoses with new ones.
OIL FILTER REPLACEMENT
Drain the engine oil as described in the engine oil replace-
ment procedure.
Remove the oil filter cap 1 and oil filter 2.
Replace the oil filter with a new one.
NOTE:
Before replacing the oil filter cap, make sure that the spring
3
and a new O-ring 4 are installed correctly.
Make sure that the O-ring 5 behind the filter is in the correct
position.
1
2
4
3
5

Suzuki drz 400E Specifications

General

Displacement	398 cc
Compression Ratio	12.2:1
Ignition	Electronic ignition (CDI)
Transmission	5-speed constant mesh
Rear Suspension	Link type, coil spring, oil damped
Front Tire	80/100-21
Rear Tire	110/100-18
Engine Type	4-stroke, DOHC
Bore x Stroke	90.0 mm x 62.6 mm
Fuel System	Mikuni BSR36 carburetor
Front Brakes	Disc
Rear Brakes	Disc
Fuel Tank Capacity	10.0 L (2.6 US gallons)
Overall Width	825mm (32.5 inches)
Ground Clearance	315 mm (12.4 in)
Seat Height	935 mm (36.8 in.)
Curb Weight	138 kg (304 lbs)
Dry Weight	119 kg (262 lbs.)