ENGINE
3-32
Fit the crankcase separator, so that the tool plate is parallel
with the end face of the crankcase.
Remove the right crankcase with the special tool.
Remove the gear shifting hub fixing spring.
Remove the gear shifting shafts, take off the forks.
Remove the gear shifting hub.
Remove the crankshaft with the special tool.
Remove the transmission assembly.
: Crankcase separator09920-13120
09920-13120: Crankcase separator
The crankshaft and transmission components must
remain in the left crankcase half, This is necessary
because the gear shifting cam stopper is mounted on
the left crankcase half and will be damaged if the
transmission components remain in the right half.
WARNINGWARNINGWARNING
,
NOTE:
Two kinds of gear shifting forks, and are used.
They resemble each other very closely in extermal
appearance and configuration. Carefully examine the
illustration for correct installing positions and
directions.
1
2
To Next Page
Loading...
