PERIODIC MAINTENANCE
2-13
REAR BRAKE
H
Rear brake pedal height
Rear brake pedal travel
Adjust the brake pedal limit screw to set the brake pedal at
the position of 10-20mm higher than the footrest, then tighten
the locking nut.
Rear brake travel is the distance from stepping on the brake
pedal until the brake begins taking effect
Turn the rear brake adjuster to adjust the travel to 20-30
mm.
.
Rear brake pedal height : 10-20 mm
Brake pedal travel : 15~25 mm
Adjust rear brake light switch so that brake light will come on
just before a pressure is felt when the brake pedal is stepped.
REAR BRAKE LIGHT SWITCH
REAR BRAKE LINING WEAR LIMIT
The motorcycle is equipped with brake lining wear limit
indicator on rear brakes. To check wear of the break lining,
follow the steps below.
Check if the brake system is properly adjusted first.
While operating the brake, check to see the extension line 1
from the index mark is within the range on the brake panel.
If the index mark is outside the range as shown in the
illustration at right, the brake shoes should be replaced to
ensure safe operation.
2
1
2
3
2
1
2
To Next Page
Loading...
