Suzuki GN125F - Oil Seal

CHASSIS
5-16
REASSEMBLY
INNER RACES
OUTER RACE
09940-34513: Steering race installer
09941-74910 : Steering bearing installer
STEEL BALL
Reassemble and remount the steering stem in the reverse
order of removal, and carry out the following steps:
Press in the upper and lower inner races with a special tool.
Apply grease to the upper and lower inner races when
installing the steel balls.
Apply grease on the new lower oil seal
Press in the lower outer race with the special tool.
.
99000-25010 : Super grease ”A”
99000-25010 : Super grease ”A”
Tighten the steering stem nut to 40-50 N•m by using the
special tool.
Turn the steering stem right ang left, lock-to-lock, five or
six time to seat the ball bearings.“”
STEERING STEM NUT
09941-14911: Steering nut socket wrench
Steer stem bolt: 40~50 N•m