Suzuki GN125F - Gear Shifting Shaft

ENGINE
3-26
GEAR SHIFTING SHAFT
REMOVAL
Reassemble the gear shifting shaft in the reverse order of
removal, pay attention to the following points:
Check the return spring for damage, gear shifting shaft 8
for wear or bending.
Remove the gear shifting shaft
Remove the screws, gear shifting cam guide plate and .
Remove the gear shifting driven gear , pawl , gear
shifting pawl pin and return spring
.
.
Remove gear shifting lever.
Remove the clutch. (Refer to page 3-20)
INSPECTION
REASSEMBLY
When installing the gear shifting pawls to the driven gear
the large shoulder must face to the outside as shown.
Install the cam guide. Apply a small quantity of THREAD
LOCK “1342" to the threaded parts of the securing screws.
,
99000 32050: Thread lock “1342"-
7
1
2
3
4
5
6
7
A