ENGINE
3-35
Install the bearings on the left and right crankcase with the
special tool.
Reassemble in the reverse order of removal, pay attention
to the following points:
REASSMEBLY
09913-70210: Bearing installer
BEARING
CRANKSHAFT
Decide the width between the webs when rebuilding the
crankshaft.
Width between webs:
Standard: 52.9-53.1 mm
09910 32812: Crankshaft installer-
When mounting the crankshaft in the crankcase, it is
necessary to pull its left end into the crankcase.
To Next Page
Loading...
