Suzuki LT-A400 - Page 111

Engine Mechanical: 1D-37
Crankcase
1) Remove the crankcase bolts.
2) Separate the crankcase with the special tool.
NOTE
• The crankcase separator plate is parallel
with the end face of the crankcase.
• The crankshaft must remain in the left
crankcase half.
Special tool
(A): 09920–13120 (Crankcase separating
tool)
Transfer Gearshift
1) Remove the reverse idle gear assembly (1).
2) Remove the transfer input shaft (2).
3) Remove the gearshift forks and transfer output shaft
assembly (3).
4) Remove the gearshift cam assembly (4).
5) Remove the front output shaft (5) and rear output
shaft (6). (LT-A400F)
6) Remove the rear output shaft (6). (LT-A400)
I827H1140112-01
I827H1140113-01
(A)
I827H1140114-01
1
2
I827H1140115-01
3
4
I827H1140116-01
6
5
I827H1140117-01