3C-15 Transfer:
Transfer Related Parts Inspection (LT-A400/F)
B827H13306010
Refer to “Transfer Removal and Installation (LT-A400/F)
(Page 3C-4)” and “Transfer Disassembly and Assembly
(LT-A400/F) (Page 3C-9)”.
Gearshift Fork to Groove Clearance
NOTE
The clearance for each gearshift fork plays
an important role in the smoothness and
positiveness of the shifting action.
Using the thickness gauge, check the gearshift fork
clearance in the groove of its dog.
If the clearance checked is noted to exceed the limit,
replace the fork or its dog, or both.
Special tool
(A): 09900–20803 (Thickness gauge)
Gearshift fork to gearshift fork groove clearance
Standard (Reverse/Low & High): 0.10 – 0.30 mm
(0.0040 – 0.0120 in)
Service limit: 0.50 mm (0.020 in)
Gearshift Fork Groove Width
Measure the gearshift fork groove width using the
vernier calipers.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Gearshift fork groove width
Standard (Reverse/Low & High): 5.5 – 5.6 mm (0.217
– 0.220 in)
Gearshift Fork Thickness
Measure the gearshift fork thickness using the vernier
calipers.
Special tool
(A): 09900–20102 (Vernier calipers (1/20 mm,
200 mm))
Gearshift fork thickness
Standard (Reverse/Low & High): 5.3 – 5.4 mm (0.209
– 0.213 in)
Transfer Related Parts Inspection (LT-F400/F)
B827H13306022
Refer to “Transfer Removal and Installation (LT-F400/F)
(Page 3C-7)”.
Gearshift Fork to Groove Clearance
NOTE
The clearance for each gearshift fork plays
an important role in the smoothness and
positiveness of the shifting action.
Using the thickness gauge, check the gearshift fork
clearance in the groove of its dog.
If the clearance checked is noted to exceed the limit,
replace the fork or its dog, or both.
Special tool
(A): 09900–20803 (Thickness gauge)
Gearshift fork to gearshift fork groove clearance
Standard (Transfer): 0.10 – 0.30 mm (0.0040 – 0.0120
in)
Service limit: 0.50 mm (0.020 in)
(A)
I831G1330066-01
(A
I649G1520057-03
(A)
I649G1520058-03
(A)
I831G1330066-01
To Next Page
Loading...
