Suzuki LT-A400 - Repair Instructions; Engine Oil and Filter Replacement; Engine Oil Level Inspection; Oil Sump Filter Removal and Installation

1E-5 Engine Lubrication System:
7) Stop the engine and remove the oil pressure gauge
and attachment.
8) Reinstall the main oil gallery plug (1) and tighten it to
the specified torque.
CAUTION
!
Use a new gasket to prevent oil leakage.
Tightening torque
Main oil gallery plug (a): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
9) Check the engine oil level. Refer to “Engine Oil and
Filter Replacement in Section 0B (Page 0B-7)”.
10) Reinstall the removed parts.
Repair Instructions
Engine Oil and Filter Replacement
B827H11506001
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-7)”.
Engine Oil Level Inspection
B827H11506002
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-7)”.
Oil Sump Filter Removal and Installation
B827H11506003
Removal
1) Remove the engine protector. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-3)”.
2) Drain engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-7)”.
3) Remove the oil sump filter cover (1).
4) Remove the oil sump filter (2).
Installation
Install the oil sump filter in the reverse order of removal.
Pay attention to the following points:
• Apply grease to new O-ring.
CAUTION
!
Use new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(a)
1
I827H1150047-01
1
2
I827H1150009-02
I827H1150020-01