Suzuki LT-A400 - Ignition; Starter Control Relay Removal and Installation; Ignition; Starter Control Relay Inspection; Parking Brake Switch Inspection; Gear Position Switch Inspection

Starting System: 1I-8
4) Connect the neutral switch diode.
5) Install the left inner fender. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
Ignition / Starter Control Relay Removal and
Installation
B827H11906010
Removal
1) Remove the rear fender. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
2) Remove the ignition/starter control relay (1).
Installation
Install the ignition/starter control relay in the reverse
order of removal.
Ignition / Starter Control Relay Inspection
B827H11906011
Inspect the ignition/starter Control relay in the following
procedures:
1) Remove the ignition/starter control relay. Refer to
“Ignition / Starter Control Relay Removal and
Installation (Page 1I-8)”.
2) Check the insulation between “A” and “B” terminals
using the multi-circuit tester.
3) Apply 12 V to terminals “C” and “D” ((+) to “C” and (–
) to “D”) and check the continuity between “A” and
“B”. If there is no continuity, replace the ignition/
starter control relay with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
4) Install the ignition/starter control relay in the reverse
order of removal.
Parking Brake Switch Inspection
B827H11906012
Inspect the parking brake switch in the following
procedures:
1) Remove the left inner fender. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
2) Disconnect the parking brake switch coupler (1).
3) Inspect the parking brake switch for continuity with
the tester. If any abnormality is found, replace the
parking brake switch with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the parking brake switch inspection,
reinstall the removed parts.
Gear Position Switch Inspection
B827H11906013
LT-A400/F
Inspect the gear position switch in the following
procedures:
1) Remove the rear fender. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
1
I827H1190016-01
“B”
“A”
“C”
“D”
I831G1190020-01
1
I827H1190017-01
WBl
Color
Position
ON
OFF
I831G1190022-01