Suzuki LT-A400 - Specifications; Service Data (LT-A400;F, LT-F400; Tightening Torque Specifications; Special Tools and Equipment

Ignition System: 1H-7
3) Disconnect the ignition switch coupler (1) (Green).
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following point:
• Route the wiring harness properly. Refer to “Wiring
Harness Routing Diagram in Section 9A (Page 9A-8)”.
Specifications
Service Data (LT-A400/F, LT-F400/F)
B827H11807001
Electrical
Unit: mm (in)
Tightening Torque Specifications
B827H11807002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
Special Tools and Equipment
Special Tool
B827H11808001
1
I827H1180011-01
Item Specification Note
Spark plug
Type
NGK: CR7E
DENSO: U22ESR-N
Gap
0.7 – 0.8
(0.028 – 0.031)
Spark performance Over 8 (0.3) at 1 atm.
CKP sensor resistance 130 – 250 Ω Bl – G
CKP sensor peak voltage 4.0 V and more (+) Bl, (–) G
Ignition coil resistance
Primary 0.1 – 1.0 Ω (+) Terminal – (–) Ground
Secondary 12 – 22 kΩ Plug cap – (+) Terminal
Ignition coil primary peak voltage 180 V and more When cranking
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Spark plug 11 1.1 8.0 )(Page 1H-3)
09900–25008 09930–10121
Multi-circuit tester set Spark plug wrench set
)(Page 1H-4) / )(Page 1H-
4) / )(Page 1H-5) /
)(Page 1H-6)
)(Page 1H-3) / )(Page 1H-
3)