1D-44 Engine Mechanical:
Crankshaft
• When installing the crankshaft in the crankcase, it is
necessary to pull its left end into the crankcase with
the special tools.
Special tool
(A): 09910–32812 (Crankshaft installer)
(B): 09940–52861 (Front fork oil seal
installer)
CAUTION
!
Never fit the crankshaft into the crankcase by
striking it with a plastic hammer.
Always use the special tools, otherwise the
accuracy of the crankshaft alignment will be
affected.
• Install the gearshift cam stopper. Refer to “Transfer
Gearshift Shaft No. 2 / Gearshift Cam Plate Removal
and Installation (LT-A400/F) in Section 3C (Page 3C-
17)”.
Balancer
• Install the balancershaft (1).
• Install the key (2).
• Install the balancershaft driven gear (3) with aligning
the punch marks.
Transfer / Gearshift
• Install the front output shaft (1) and rear output shaft
(2). (LT-A400F)
• Install the rear output shaft (2). (LT-A400)
• Install the C-ring (3).
NOTE
Be sure to fit the pin “A” on the bearings into
the groove of the crankcase.
(A)
(B)
I827H1140261-01
1
2
I827H1140152-01
3
I827H1140153-02
1
2
I827H1140154-01
3
I827H1140155-01
To Next Page
Loading...
