Differential: 3B-8
14) Remove the bearing from the pinion gear with the
special tool.
NOTE
If there is no abnormal condition, the bearing
removal is not necessary.
Special tool
(E): 09913–70210 (Bearing installer set)
15) Remove the pinion gear pilot bearing with the special
tools.
Special tool
(F): 09921–20210 (Bearing remover)
(D): 09930–30104 (Rotor remover slide
shaft)
NOTE
If there is no abnormal condition, the bearing
removal is not necessary.
16) Remove the C-rings (9) from the universal joint.
17) Remove the bearings by tapping with the special tool
and hammer.
Special tool
(E): 09913–70210 (Bearing installer set)
18) Remove the universal joint (10).
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
19) Remove the 2WD/4WD shifting fork (11), spring (12)
and (13) by removing the E-rings (14) and shaft.
20) Remove the shifting fork shaft oil seal out of the case
cover with a suitable tool.
NOTE
If there is no abnormal noise, the bearing
removal is not necessary.
(E)
I827H1320026-01
(F)
(D)
I827H1320022-02
9
9
I827H1320023-03
(E)
10
I827H1320024-04
11
12
13
14
I827H1320025-01
I827H1320114-01
To Next Page
Loading...
