Suzuki LT-A400 - Page 388

4C-6 Rear Brakes:
• Install the brake camshaft (1) and washer (2).
• Install the spring (3) with the spring end hooked to the
hole on the brake panel.
• Install the brake cam lever (4) to the brake camshaft
(1).
• Align the punched mark “A” on the brake cam lever
with the slit “B” on the brake camshaft (1).
• Tighten the brake cam lever nut to the specified
torque.
Tightening torque
Rear brake cam lever nut (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
• Install a new O-ring (5) and apply soap water to it.
CAUTION
!
Replace the O-ring (5) with a new one.
• Apply bond to the mating surface of the brake panel.
: Sealant 99000–31230 (SUZUKI BOND
No.1216B or equivalent)
• Install the new O-ring (6) onto the rear axle housing.
CAUTION
!
Replace the O-ring (6) with a new one.
• Install the brake anchor panel (7) to the rear axle
housing.
• Apply thread lock to the bolts and tighten them to the
specified torque.
: Thread lock cement 99000–32130
(THREAD LOCK CEMENT SUPER 1360 or
equivalent)
Tightening torque
Rear brake anchor panel bolt (b): 32 N·m (3.2 kgf-
m, 23.0 lb-ft)
1
3
2
I827H1430015-01
(a)
1
4
“A”
“B”
I827H1430016-02
5
I827H1430017-01
6
I827H1430018-01
(b)
(b)
7
I827H1430019-02