1D-54 Engine Mechanical:
Oil Pump
• Install the dowel pins.
• Install the oil pump (1).
• Install the washer (2) and pin (3).
• Install the oil pump driven gear (4) as shown in the
figure.
NOTE
Install the oil pump driven gear as shown in
the figure.
• Install new snap ring.
CAUTION
!
Never reuse the removed snap ring.
Special tool
: 09900–06107 (Snap ring pliers)
• Install the pin (5).
• Install the oil pump drive gear (6) and washer (7).
• Apply thread lock to the oil pump drive gear bolt.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
NOTE
Flange side of the oil pump drive gear is
positioned inside.
• Tighten the oil pump drive gear bolt to the specified
torque with the special tool.
Tightening torque
Oil pump drive gear bolt: 80 N·m (8.0 kgf-m, 58.0
lb-ft)
Special tool
(A): 09930–40113 (Rotor holder)
“A”: Inside side
1
2
3
I827H1140197-01
4
“A”
I827H1140198-01
5
6
7
I827H1140199-01
(A)
I827H1140200-01
To Next Page
Loading...
