ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE) 6A1-75
D If necessary, regrind crankshaft journal and select under-size
bearing to use with it as follows.
1) Regrind journal to the following finished diameter.
Finished diameter: 44.732 – 44.750 mm
(1.7611 – 1.7618 in.)
2) Using micrometer, measure reground journal diameter.
Measurement should be taken in two directions perpendicular
to each other in order to check for out-of-round.
3) Using journal diameter measured above and alphabets
stamped on mating surface of cylinder block, select an under-
size bearing by referring to table given below.
Check bearing clearance with newly selected undersize bear-
ing.
Measured journal diameter
44.744 – 44.750 mm
(1.7616 – 1.7618 in.)
44.738 – 44.744 mm
(1.7613 – 1.7616 in.)
44.732 – 44.738 mm
(1.7611 – 1.7613 in.)
Alphabets stamped
A Green & Red Black & Red Red only
on mating surface
B Black & Red Red only Yellow & Red
of cylinder block
C
Red only Yellow & Red Blue & Red
Undersize bearing to be installed
Rear Oil Seal
Carefully inspect oil seal (1) for wear or damage. If its lip is worn or
damaged, replace it.
For oil seal installation, press-fit rear oil seal (1) so that oil seal
housing (2) end face is flush with oil seal end face.
To Next Page
Loading...
Need help?
General
