Swegon AB
Box 300
S-535 23 Kvänum, Sweden
declare under our own sole responsibility that
Air handling units with the following designation:
GOLD RX, GOLD PX, GOLD CX, GOLD LP, GOLD SD
and any accessories to the respective designation covered by these directives
comply with the Machinery Directive 2006/42/EC
and also to the following directives
2004/108/EG EMC, (Electromagnetic Compatibility Directive)
2006/95/EG LVD, (Low voltage directive)
The following harmonised standards have been applied:
EN ISO 12100:2010 (Machinery safety – General principle for design – Risk assessment
and risk reduction)
EN ISO 13857:2008 (Safety of Machinery -, Safety distances from machinery to prevent
hazard zones being reached by upper and lower limbs)
EN 60204-1 (Safety of machinery – Electrical equipment of machines)
EN 61000-6-2, -3 (Electromagnetic compatibility)
EN 61800-3 (Adjustable speed electrical power drive systems)
The following other standards and specifications have been applied:
EN 1886:2007 (Ventilation for buildings, air handling units – Mechanical performance)
EN 13053:2006 (Ventilation for buildings, air handling units - Rating and performance for
units, components and sections)
Person authorised to compile the technical documentation:
Dan Örtengren
Box 300
SE-535 23 Kvänum, Sweden
This declaration is applicable only if the air handling unit(s) has/have been installed
according to Swegon’s instructions and provided that the air handling unit(s) has/have not
been modified in any way.
Kvänum, 01/28/2011
Thord Gustafsson, Quality and Environmental Manager, Swegon AB
To Next Page
Loading...
