Equipment details
121
• Fault 7: Senses gas output terminal OFF
when should be ON.
Action: Contact your dealer or a Thetford
Service Centre.
• Fault 8: AC mains supply is 20%
below nominal.
Action: Your controls are in manual AC
mode, but there is no power available.
Check if you plugged in the 230V
connection, if so the voltage supply on
the 230V connection is to low, contact the
power supplier.
• Fault 9: Gas lockout because flame fails to
ignite after 30 seconds.
Action: Your controls are in manual gas
mode, but the flame fails to ignite. Check if
your gas cylinder is empty or if one of the
shut-off valves is closed. Select another
energy source. Reset the fridge 3 or 4 times
in gas-mode until flame ignites. Contact
your dealer or a Thetford Service Centre if
problem isn’t resolved.
• Fault 10: No “engine running” signal is
present and control is in Manual DC mode.
Action: Your controls are in manual DC
mode and the engine of your vehicle is
not running. The refrigerator can only cool
on 12V when the engine of your vehicle
is running. Start the engine or select a
different energy mode.
• Fault 11: No energy source is available and
control is in AUTO mode.
Action: Your controls are in AUTO mode,
but no energy source is available. Start the
engine, connect the 230V supply or open
the gas supply and reset the refrigerator by
turning it of and on again.
• Fault 12: Contact your dealer or a Thetford
Service Centre.
• Fault 13: Thermistor fails; control
automatically switches to Backup
mode (BOS).
Action: Check if the connector above the
fin on the inside of the cabinet is correctly
plugged in. If so contact your dealer or a
Thetford Service Centre.
• Fault 14: Display Board and Power board
lost communication with each other.
Action: Contact your dealer or a Thetford
Service Centre.
• Fault 18: No fault, only lighting all LCD
segments on start-up.
Action: Wait a few seconds for the fridge to
start up normally.
To Next Page
Loading...
