EasyManua.ls Logo

Swift Group 2011 - Truma S 3002 Auto Space Heater

Default Icon
179 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Equipment details
71
The instructions covering fitted equipment to
your vehicle were correct at the time of going
to print. Owners handbooks are updated
annually and we take great care to try and
ensure their accuracy. However, the Swift
Group Limited cannot accept responsibility
for any changes that may be made in
specification or operating instructions to the
equipment described in this section after the
time of going to press.
Every care is taken to ensure that the
information provided in this handbook is
correct and easy to understand.
Separate manufacturers’ leaflets on many
of the components are also included in the
Owner’s Pack provided with this vehicle
and we recommend that you compare
the instructions in the handbook with
the component manufacturers literature,
to ensure the information provided is as
accurate as possible.
If you are in any doubt as to how to operate
the equipment in your vehicle, please contact
the component manufacturer’s service
department on the telephone number shown
on their component leaflet. If you remain in
any doubt, please contact the Swift Group
Supercare customer care service department
on 01482 875740.
Equipment Specification
For details on type of equipment fitted in
your vehicle, please refer to the Sales Brochure
or Dealer.
IMPORTANT
To maximise the use and life of all fitted
equipment in your vehicle it is essential that
any accompanying manufacturers’ literature is
read fully. All recommended maintenance and
preparation procedures should be followed.
The information provided in this handbook is
only intended as a guide. If in any doubt consult
your manufacturer appointed dealer, particularly
before attempting to install EXTRA EQUIPMENT.
NOTICE: In the interest of safety,
replacement parts for an appliance shall
conform to the appliance manufacturer’s
specifications and should be fitted by
them or their authorised agent.
TRUMA ULTRA-STORE
WATER HEATER
The water heater features a system that
will heat water using liquid petroleum gas
or 230V mains electricity. The heater can
be simultaneously operated on gas and
electricity to give a faster warm-up period.
The cassette has a capacity of 10 Iitres.
Attention: Always fit the cowl cap when
the water heater is not being operated!
Drain the water heater if there is risk of
frost and preferably when you leave the
site. Leave all taps open. Frost damage is
not covered by the warranty!
Filling the Truma-Ultrastore with water
1. Check that the safety/drain valve in the cold
water intake is closed. Lever should be in
horizontal position, position (e) Fig. 1.
Fig. 1
e = Lever position
‘Closed’
f = Lever position
‘Drain’
2. Open hot tap in bathroom or kitchen; set
pre-selecting mixing taps or single lever
fittings to ‘hot’.
3. Switch on power for water pump. Leave the
tap open to let air escape while the water
heater is filling. The heater is full when
water flows freely from the tap.

Table of Contents

Related product manuals