Equipment details
150
TABLE STORAGE
Tables stored in the table storage
compartment must be securely clipped into
place whilst in transit.
To avoid damage care must be taken when
removing tables from their stored position.
CARE OF LAMINATE TOPS,
TABLES, FURNITURE AND DOORS
DO NOT use abrasives, chemically treated
cloths or aggressive detergents as these may
cause damage.
DO NOT place hot objects on laminated
surfaces i.e. tops, tables. Any temperatures
70°C and over will cause permanent damage.
Clean worktop surfaces, furniture and door
fascias with a soft, slightly damp cloth, dry off
with a soft cloth.
SHOWER
When using the shower, always ensure that the
shower door is fully closed thus avoiding water
spray on unprotected areas.
12V READING LAMP
Warning: 12v reading/spotlamps generate
high temperatures when in use, the body,
lens/bulb may become very hot.
Never make directional adjustment in
the direction of flammable materials i.E.
Curtains, nets or blinds.
OMNISTEP SINGLE STEP
Operation
The OMNISTEP is operated by the lever switch.
Important: when extending the step, hold the
switch until the step is completely extended.
Never mount the step if retracted of if not fully
extended, because then the blocking is not
working and the motor can be damaged.
Check if the step is retracted before departure.
Maintenance
Dirt and frost can prevent the step from
operating properly. In this case the moving
parts should be cleaned or defrosted.
All points of movement are layered in
maintenance-free bearings.
In case of electrical failure
If the step does not retract by motor: Loosen
To Next Page
Loading...
