Equipment details
144
WINDOWS
To open, turn knobs anti-clockwise and open
catches. Swivel the window pane open to the
desired position and close knobs clockwise to
lock in the open position.
To close, reverse the operation.
All opening windows have two catch positions.
The first position is for ventilation the second
seals the window from ventilation and rain.
KOMFORTROLLO BLINDS (SEITZ)
Blinds and Flyscreens
Flyscreen and blinds operate in the same
manner. The flyscreen can only be ‘fully up’
or ‘fully’ down, but the blind also has an
intermediate position.
To operate, pull down by holding the
fingergrip(s), gently ease towards the window to
locate the catches. To retract, pull down easing
away from the window to release the catches
and guide to the required position.
• Only operate by holding the fingergrip(s)
- pulling on one side will cause uneven
running and snagging.
• Do not allow the blind or flyscreen to re-coil
without control.
• It is not recommended that blinds and/or
flyscreens are left in the down position for
long periods, or when travelling, as this can
result in fatigue of the spring.
• Clean the cassette, side track and fabrics
with mild detergent and water.
• Lubrication of mechanism or spring is not
required or recommended.
For more detailed information, see
manufacturer’s instructions.
Cassette Blind and Flyscreen
Always hold the end rod in the middle. When
closing blinds, slide the end rod of the flyscreen
blind on to the end rod of the sun blind and
engage. To open the blind push the end rods
towards the darkening blind to the edge and
disengage the end rods. Now move the end rod
of the flyscreen back by hand - do not let it recoil.
Tensioning Seitz blinds and flyscreens
Seitz Komfortrollo window blinds/flyscreens are
pre-tensioned, it may also be necessary in the
future to adjust the tension of these. Remove
the left hand top corner cap. Adjust the lower
screw for the blind and the higher screw for
the flyscreen. Care should be taken not to over
tighten the springs.
The spring in the Seitz cassette window blinds/
flyscreens are pre-tensioned. However, it may
be necessary in the future to adjust the tension.
The tensioning screw is positioned on the right
To Next Page
Loading...
