Equipment details
128
SpinFlo COOKER 3 BURNER
IMPORTANT: Before using the appliances
for the first time, remove all accessories and
packing in the grill and oven, including any
surface protection film, i.e. plastic coating.
Clean all interior surfaces with hot soapy water
to remove any residual protective covering of
oil and rinse carefully.
WARNING
• ACCESSIBLE PARTS MAY BE HOT WHEN
THE GRILL IS USED, YOUNG CHILDREN
SHOULD BE KEPT AWAY.
• WHEN COOKING ALWAYS ENSURE
YOUNG CHILDREN ARE KEPT AWAY.
Ensure the gas cylinder is turned on. In the
event of a gas smell, turn off at the cylinder and
contact supplier. The burners on this appliance
have fixed aeration and no adjustment is
required. Depending on the gas being used, the
burners should flame as follows:
PROPANE - The flames should burn quietly
with a blue/green colour with no sign of yellow
tips.
BUTANE - Normally on initial lighting, as small
amount of yellow tipping will occur and then
slightly increases as the burner heats up.
IMPORTANT: The control tap on this appliance
operates both the grill and oven burners.
To ensure safe operation it is not possible to
operate both burners at the same time.
Using the hob burners
1. Ensure gas cylinder/supply is connected and
turned on. In the event of a gas smell turn off
at gas cylinder/mains and contact supplier
2. Flame supervision: Each burner is
controlled individually and is monitored
by a thermocouple probe. In the event
of the burner flames being accidentally
extinguished, turn off the burner control and
do not attempt to re-ignite the burner for at
least one minute.
3. To light: Push in the control knob and turn
to full rate - see Fig.2. Hold a lighted match
or taper to the burner and push the control
knob in and hold. It is necessary to hold the
knob depressed after the burner has ignited
or approximately 10-15 seconds, to allow the
thermocouple probe to reach temperature,
before releasing the knob. Should the flame
go out when the knob is released, the
procedure should be repeated holding the
knob depressed for slightly longer.
4. For models fitted with spark ignition the
procedure is similar except that the burner
can be ignited by depressing the ignition
button, which is located on the fascia. If
the burner has not lit within 15 seconds the
control knob should be released and the
burner left for at least 1 minute before a
further attempt to ignite the burner.
5. For simmering, turn the knob further anti-
clockwise to the low rate position.
6. To turn off: Turn the control know until the
line on the control knob is aligned with the
dot on the control panel. Always make sure
the control knob is in the off position when
you have finished using the hotplate burners.
IMPORTANT: The two in line hob burners on
this appliance will support pans from 10cm to
20cm. The single hob burner will support pans
from 10cm to 22cm.
WARNING
• GLASS LIDS MAY SHATTER WHEN
HEATED. TURN OFF THE HOTPLATE AND
ALLOW IT TO COOL BEFORE CLOSING
THE GLASS LID.
• REMOVE ALL SPILLAGE FROM THE
SURFACE OF THE GLASS LID BEFORE
OPENING.
Using the grill
IMPORTANT
• THE GRILL MUST ONLY BE USED WITH
THE DOOR OPEN.
• THE HEAT DEFLECTOR BELOW THE
FASCIA SHOULD BE PULLED OUT PRIOR
TO LIGHTING THE GRILL. NEVER ADJUST
THE HEAT DEFLECTOR POSITION
WITHOUT USING HAND PROTECTION I.E.
OVEN GLOVES.
To Next Page
Loading...
