Equipment details
127
DO’S AND DON’TS
DO read the user instructions carefully before
using the appliance for the first time.
DO allow the oven to heat before using for
the first time, in order to expel any smells
before the introduction of food.
DO clean the appliance regularly.
DO remove spills as soon as they occur.
DO always use oven gloves when removing
food shelves and trays from the oven.
DO check that controls are in the off position
when finished.
DO NOT allow children near the cooker when in
use. Turn pan handles away from the
front so that they cannot be caught
accidentally.
DO NOT allow fats or oils to build up in the
oven trays or base.
DO NOT use abrasive cleaners or powders
that will scratch the surfaces of the
appliance.
DO NOT under any circumstances use the
oven as a space heater.
DO NOT put heavy objects onto open grill and
oven doors.
LEAKS
If a smell of gas becomes apparent, the supply
should be turned off at the cylinder
IMMEDIATELY. Extinguish naked lights
including cigarettes and pipes. Do not operate
electrical switches. Open all doors and
windows to disperse any gas escape. LPG
gas is heavier than air; any escaping gas will
therefore collect at a low level. The strong
unpleasant smell of gas will enable the general
area of the leak to be detected. Check that
the gas is not escaping from an unlighted
appliance. Never check for leaks with a naked
flame, leak investigation should be carried out
using a leak detector spray.
MAINTENANCE & SERVICING
IMPORTANT
• Shut off gas supply at isolating valve, switch
off electric supply and ensure all parts are
cool before cleaning or servicing
• All servicing must be carried out by an
approved competent person.
• After each service the appliance must be
checked for gas soundness
• This appliance must not be modified or
adjusted unless authorized and carried out
by the manufacturer or his representative.
No parts other than those supplied by
the manufacturer should be used on this
appliance.
• If the supply cord is damaged, it must only
be replaced by the manufacturer or his
representative in order to avoid a hazard.
This appliance needs little maintenance other
than cleaning. All parts should be cleaned
using warm soapy water. Do not use abrasive
cleaners, steel wool or cleansing powders.
When cleaning the burner ring it is essential to
ensure that the holes do not become blocked.
The control knobs are a push fit and can be
removed for cleaning. They are interchangeable
without affecting the sense of operation.
To Next Page
Loading...
