Equipment details
152
OMNISTEP DOUBLE STEP
Operation
Press the ‘step out’ key to bring the step out
until it reaches the end of its run or comes up
against an obstacle. The step does not come
out if the the engine is running. Press the ‘step
in’ key to take the step back until it reaches the
end of its run or comes up against an obstacle.
The step goes back in automatically when the
engine is running. In this situation the buzzer
sounds until the step is fully closed.
Never mount the step if retracted or if not
fully extended
Maintenance
Dirt and frost can prevent the step from
operating properly. In this case the moving
parts should be cleaned or defrosted. All points
of movement are layered in maintenance-free
bearings.
In case of electrical break down
If the step does not retract by motor:
• Loosen the square connection according to
fig. 2 (actions 1, 2 and 3), push the footboard
in (4) and tie it to the frame (fig. 3).
Current drawn
• 7 A. When fully extended or retracted: 19 A
Fig. 1
Fig. 2
Fig. 3
To Next Page
Loading...
