EasyManua.ls Logo

SWM Superdual E4 2017 - Central Stand; Sidestand

SWM Superdual E4 2017
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
1
2
3
3
2
EN - 10
SIDESTAND
A kickstand (1) is supplied with every motorcycle.
WARNING*: The stand is designed to support
the weight of the MOTORCYCLE ONLY. Do not
sit on the motorcycle using the stand for sup-
port as this could cause structural failure to
the stand and could cause serious bodily in-
jury.
WARNING*:
The motorcycle must ONLY be stood on its
kickstand AFTER the rider has dismounted.
Once the motorbike has been brought from
its rest position on the ground into vertical po-
sition, the driver has to raise the stand from
the lowered to the raised position with his left
foot.
WARNING*: A safety sensor (2) is fitted on the
motorbike, which allows starting it with the
stand lowered and the gear in neutral.
If a gear is engaged with the stand lowered,
the engine turns off.
CENTRAL STAND
- Grab the left knob (1) of the handle and the rear
left large handle (2).
- Press the tip of the central stand with the right
foot and lift the motorcycle upward and back-
ward at the same time, until it is fully lifted on
the central stand (3).
WARNING*: When the vehicle is parked on the
central stand, it is dangerous to sit on it, load-
ing your weight on the parking stand.
To lower the motorcycle from the central stand,
proceed as follows.
- Grab the left handlebar (1) grip and the rear (2)
left large handle.
- Push the motorcycle toward the front, until it de-
scends from the stand; the stand will automati-
cally lift.

Table of Contents

Other manuals for SWM Superdual E4 2017

Related product manuals