Chapter 4 Provisioning the TimeProvider
System Commands
128 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005
System Commands
This section describes the TL1 commands you use to perform the following routine
operations with the TimeProvider:
îš„ Displaying events
îš„ Displaying the current configuration
îš„ Restarting the TimeProvider
Displaying Events
The RTRV-LOG command displays all the events in the event log in chronological
order (first in - first out). The event log contains the 500 most recent alarmed and
non-alarmed events. Alarms with an alarm level of NONE are not stored in the log.
RTRV-LOG:[<tid>]:[<aid>]:[<ctag>][::<keyword>=<value>];
This command has a default access level of USER.
Sample Command
RTRV-LOG::INP1:TS1000::ALM;
This command causes the TimeProvider to return all alarms stored in the log for
Input 1.
<aid> <keyword> Description
ALL (or null)
IMC
IOC
IOCm (m = 1 | 2)
GPS
PRS
INPp (p = 1 | 2)
OUTg (g = A | B |
C | D)
Access identifiers
All (or null) Displays both events and
alarms stored in the log for the
specified aid
EVT Displays events stored in the
log for the specified event
ALM Displays alarms stored in the
log for the specified event
To Next Page
Loading...
Need help?
General
