Symmetricom TimeProvider 1100 User Manual

097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 159
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
RESET The IMC has been
reset by user
command
EQPT n/a n/a
SIDCHG The source ID has
changed in the
database
EQPT n/a 20-character name used to
identify the network
element
UIDCHG A user’s name has
changed in the
database
EQPT uid User Identification – up to
20 characters
USRADD A user has been
added to the
database
EQPT uid
pid
uap
uid – assigned user name
pid – assigned user
password
uap – assigned user access
level
USRDEL A user has been
deleted from the
database
EQPT uid uid – username
XFERFAIL Transfer of the IMC
Istate to the IOC,
transfer of the IOC
Istate to the IMC, or
transfer of the IOC
Istate to the
redundant IOC was
not successful
EQPT n/a n/a
XFEROK Transfer of the IMC
Istate to the IOC,
transfer of the IOC
Istate to the IMC, or
transfer of the IOC
Istate to the
redundant IOC was
successful
EQPT n/a n/a
IOC Event Codes
CLKTYPE The specified IOC
clock has been set to
the specified value.
This value is used to
define the IOCs
pull-in range and
SSM generation in
Holdover mode
EQPT TYPEI ST3E | TYPE I
ST2 | TYPE II
Table 6-5. Event Codes (Continued)
Event ID
Keyword
Description
AID
TYPE
Default Value/
Keyword
Description of Values

Symmetricom TimeProvider 1100 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1100
Category	Clock
Language	English