Synesso MVP Technical Manual

11
PLUMBING REQUIREMENTS
This equipment must be installed to comply with the applicable federal, state or local plumbing codes.
WATER TREATMENT IS REQUIRED TO PRESERVE THE FULL MACHINE WARRANTY. Please ensure that the
incoming water complies with the warranty requirements listed on page 7.
Using the provided stainless steel braided hose, connect the pump to the shuto valve on the ltered cold
water line. Fings on the hoses and pumps are 3/8” tube compression. Thread sealant or Teon tape is
not necessary. Make connecons snug, but do not over ghten.
Turn incoming water ON and check for leaks.
Synesso™machines require a minimum of 50 PSI (3.5 bar) of line pressure at 30gal (120L) per hour to have
the auto-ll system for the steam tank funconing properly. Please ensure that the incoming water meets
this requirement or contact Synesso™for alternave methods of boosng water pressure.
NOTE: Synesso™sells a “Euro-hose” adaptor hose and ng (part number is 1.5020) which converts from a
3/8” tube ng to a pipe ng, suitable for most non-US plumbing. Please refer to the picture below to
idenfy the dierences between the standard and Euro-style ngs and hoses.
1/4” NPT
3/8” Tube Compression
3/8” BSP Pipe
Standard Fing - #1.5620
Standard Hoses -
48” #1.5060
84” #1.5070
Euro Hose - #1.5010
Euro Fing - #1.5000
(Euro Assembly - #1.5020)

Synesso MVP Specifications

General

Brand	Synesso
Model	MVP
Category	Coffee Maker
Language	English